Twin-Star International 25MM5045 Manual De Instrucciones página 5

SAFETY INFORMATION
WARNING
• Before assembly, carefully use scissors or utility knife to cut and unwrap all parts.
Make sure you do not discard the hardware.
CAUTION
• Use care in assembling your new fireplace. Take your time and use the hardware
provided and a quality Phillips head screwdriver. Never overtighten bolts.
• Do not sit on any part of the mantel.
• All panels are labeled left and right as viewed from the front of unit.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 Minutes
Tools Required for Assembly (not included): Phillips head screwdriver, scissors and utility knife
ASSEMBLY INSTRUCTIONS
1. Locate the Center Left Side Panel (B), Center Right
Side Panel (C), Center Shelf (D), and set out face
down on a scratch-free surface.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Push the Center Left Side Panel and Center Right
Side Panel snug to the Center Shelf. Make sure the
Wood Dowels are seated in the pre-drilled holes.
Connect the Center Left Side Panel (B), Center
Right Side Panel (C) and Center Shelf (D) with
Connection Plate, tighten Screws (EE) through the
pre-drilled holes. Using Bolts (AA) and Washers
(BB) attach panels through pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
EE Screw
Fig. 1
AA
x 4
x 4
x 6
x 2
4
CC
BB
D
C
EE
B