Twin-Star International 25MM5045 Manual De Instrucciones página 6

2. Locate Hearth/Base (A) and set out fi nished side up
on the fl oor.
Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Attach the Completed Center Front assembly from
step 1 to the Hearth/Base (A). Make sure that
dowels are seated into the pre-drilled holes in the
Hearth/Base. Using Bolts (AA) and Washers (BB)
attach panels through pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Locate Left Side Panel (E) and Right Side Panel
(F), insert one Wood Dowel (CC) into each of the
pre-drilled holes on the bottom edge of the panels.
Then use Bolts (AA) and Washers (BB) through
the pre-drilled holes in the mounting blocks. Attach
the Side Panels to Hearth / Base (A).
HAND TIGHTEN ONLY.
Hardware Used
AA Bolt
BB
Washer
CC Wood Dowel
3. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 2. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly. From
the inside, attach Mantel/Top (G) using Bolt (AA) and
Washer (BB) through the pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
Fig. 2
F
x 8
x 8
x 8
Fig. 3
x 8
x 8
x 8
5
A
AA
BB
G
CC
BB
AA
E
CC