Twin-Star International 25MM5045 Manual De Instrucciones página 7

4. Attach Side Back Panels (J) to the back of the
completed assembly from step 3. Use a Phillips
head screwdriver, tighten Screws (EE) through the
pre-drilled holes in the Side Back Panels (J).
Hardware Used
EE Screw
5. Rest Center Back Panel (I) into groove on Mantel
Top (G) back edge. Allow the pre-installed magnets
to keep the Center Back Panel (I) in closed
position.
6. Connect the RH Front Door (L) to the RH Side
Panel (F) with the hinge pre-installed on the door,
then use a Phillips head screwdriver to tighten the
Screw (GG) through the pre-drilled holes.
REPEAT WITH LH FRONT DOOR (K) ON
OPPOSITE SIDE.
Attach the Knob (FF) to the LH Front Door (K) and
LH Side Panel (E), securing with the preassembled
bolts. Then use a Phillips screwdriver to tighten the
bolts.
Hardware Used
FF Knob (with bolt)
GG Screw
Fig. 4
x 28
Fig. 5
Fig. 6
x 2
K
x 16
6
J
EE
G
I
2
1
GG
J
FF
L