Attaching The Dial And Cover Plate - Rtb; Operation; Maintenance; Disassembly And Disposal - Schluter Systems BEKOTEC-THERM-RTBR Instrucciones De Montaje

GB
6.4 Fitting the dial and cover plate - RTB
1. Once the construction work is complete, remove the protective cap
from BEKOTEC-THERM-RTB.
2. Set the sensor unit to position "3" (Fig. 11 on page 26) when attach-
ing the cover plate. This ensures that the dial and thermostat are in
the proper position. The sensor unit is pre-adjusted at the factory.
3. Attach the cover plate with the integrated dial to BEKOTEC-
THERM-RTB.
Fig. 21: Tappet on dial

7. Operation

Set the medium temperature of the surface heating circuit at the dial inside BEKOTEC-THERM-RTBR (see 3.1.4.1 on page 23). Set the room tempera-
ture at the thermostat with remote adjustment (see 3.1.4.2 on page 24).
Set the medium temperature of the surface heating circuit at the dial of BEKOTEC-THERM-RTB (see 3.1.4.1 on page 42).

8. Maintenance

Regularly check the fittings and their connection points for leaks and functionality as part of system service.

9. Disassembly and disposal

9.1

Disposal

Risk of environmental contamination!
Improper disposal (e.g. with household garbage) can lead to environmental damage.
Dispose appropriately of packaging materials.
Caution
Dispose appropriately of building materials.
Dispose of the product unless there are return or disposal agreements.
If possible, components should be recycled.
Dispose of non-recyclable components in accordance with local regulations. Disposal in household waste is not permissible.
32
Troubleshooting / operation / maintenance / disassembly and disposal
Make sure that the wide tappet on the inside of the dial is located at
Fig. 22: Attaching the cover plate with dial
the top or in the marked position as shown in Fig. 21 on page 32.
i