Clearing Locking Authorisations; Clearing The Locking Authorisations Of Individual Keys; Erasing The Locking Authorisations Of All Keys; Operation - hafele LockerLock LL 200 Manual De Instrucciones

7. Clearing locking authorisations

7.1 Clearing
the locking
authorisations
of individual keys
7.2 Erasing the locking
authorisations
of all keys

8. Operation

8.1 Locking

8.2 Unlocking

9. Reset

9.1 Simple reset

18
For step-by-step instructions "Erasing the locking
authorisations of individual keys" see illustrations starting
on page 55.
If a user key was lost, all user keys must be cleared at the LockerLock.
For step-by-step instructions "Erasing the locking
authorisations of all keys" see illustrations starting on
page 56.
Then locking authorisation must be allocated to all of the required user keys again
(see chapter "6. Allocating locking authorisations").
• An authorised user key is needed to lock the door.
For step-by-step instructions "Operation - Locking"
see illustrations starting on page 57.
• An authorised user key is needed to unlock the door.
For step-by-step instructions "Operation - Unlocking"
see illustrations starting on page 58.
In order to rectify the error, it may be necessary to perform a reset. There are
two ways of doing this:
• Simple reset (only for maintenance purposes)
• Factory reset
The reset described here can only be carried out in the removed condition
(see chapter "Disassembly" of the installation instructions).
To carry out a reset with the MDU programming unit, please contact your Dialock
technician or Häfele.
The simple reset is exclusively for maintenance purposes in the factory.
With the simple reset, the main configuration data such as logs or keys is untouched.
However, a privileged login is no longer required for subsequent use of the MDU.
From this point in time the terminal can be manipulated with an MDU at any time.
WARNING
Warning of abuse!
In stand-alone mode, all programming, erasing and user keys remain valid
after a simple reset. In combination with the possibility to use an MDU
without a privileged login there is risk that the terminal will not be secure.
The terminal settings can be modified with an MDU at any time.
> In stand-alone mode it is essential to ensure that a factory reset is
carried out after a simple reset.