Changing The Tool (See Figure B); Starting Operation - Bosch IXO Manual De Usuario

OBJ_BUCH-2249-002.book Page 34 Wednesday, January 20, 2016 5:16 PM
34 | English

Changing the Tool (see figure B)

 Do not use double-sided screwdriver bits that are longer than 25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Adjusting the Worklight (see figure C)
By turning the rubber cap 3, you can set focused or diffused light for the work
area 10, if required. Pull the rubber cap forward and off and  place this
with the appropriate lens back on the tool holder 2.
Eccentric Driver Head/Angle Driver Head/Torque Attach-
ment (see figures C – F)
The eccentric driver head 15 enables screwdriving close to edges.
The angle driver head 16 enables screwdriving at hard to reach locations.
With the torque presetting ring 18 on the torque attachment 17, the request-
ed torque can be preset in 10 steps. With the correct setting, the tool bit is
stopped as soon as the screw is driven flush into the material or when the set
torque is reached.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3 off toward the front.
Afterwards the attachments can be mounted. The attachments can be
mounted offset by 45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring 20 in rotation direction
 and pull the attachment off toward the front. Afterwards, mount the rub-
ber cap 3 again.
Operation

Starting Operation

Reversing the rotational direction
The rotational direction switch 5 is used to reverse the rotational direction of
the machine. However, this is not possible with the On/Off switch 7 actuated.
1 609 92A 1NN | (20.1.16) Bosch Power Tools