S&P ECOHAND N Manual De Instrucciones página 10

Man
Women
Disabled
• Ensure that the wall where the appliance is to be installed is capable of withstanding the wei-
ght of the appliance (13~14 Kg) plus a safety margin.
• Ensure that the space beneath the apparatus is kept clear, so that nothing can obstruct the
entry of air into the appliance.
• You can choose which side of the appliance you would like the power cable to exit, based on
the location of the power point to which it will be connected. Simply change the route using the
plastic cable fasteners.
• Unscrew the 2 screws from the upper side (Fig. 3.11) of the unit which are fixing the Wall bracket.
• Put out the water deposit. (Fig. 3.8). Unscrew the front panel and save the screws (Fig. 3.15).
Put away the front panel (Fig. 3.16) and take out the filter box (Fig. 3.6).
• Use the Wall bracket to mark the holes.
• Drill the 4 holes (8mm) and use the delivered screws to fix the bracket on the Wall. (Fig. 3.11).
Please assure that the scews are suitable for the wall type.
• Fix the unit on the bracket (Fig. 3.11) and assure a good installation.
• Secure the unit with the anti-theft screw (Fig. 3.17) to assure that it can't be moved from the
Wall.
• Connect the appliance to an earthed power point. Press the switch (Fig. 1.4) and the appliance
is ready for use.
DIRECT CONNECTION TO THE ELECTRICITY NETWORK
• Carefully read the safety warnings listed above before installing the appliance. Ensure that the
power is completelydisconnected.
• Ensure that the power cables have the correct section for the appliance's power rating. The
length of cable protruding from the wall must be at least 40 cm and it must have a forked ter-
minal to enable the correct connection of the appliance.
• Remove the water tank (Fig. 3.8) using the plastic key supplied (Fig. 3.6).
• Remove the two screws (Fig. 3.15) that secure the front cover in place. Remove the front cover
of the appliance (Fig. 3.16) to gain access to the connection box (Fig. 3.14).
• Disconnect the factory installed cable. Insert the power cables through the hole on the back of
the appliance and connect them to the terminal strip as indicated in the diagram. The lenght of
the power supply cable has to be long enough to can make a loop on the ferrite before connect
to the connector. (Fig. 3.14)
INSTRUCTION FOR USE
• Press the ON button (Fig. 1.4), the light connected to the power supply switch on. (Fig. 1.9)
• To dry the hands please follow the instructions in the Fig. 4.
• The light indicator (Fig. 1.10) begins to countdown the drying time.
10
Measurement Y
900 mm
850 mm
775 mm