Beper VE.500 Manual De Instrucciones página 12

Mist Fan Use instructions
Components: Fig.1
1. Mist Ring
2. Front Guard
3. Safe Screw
4. Safe nut
5. Mist Ring Screw
6. Blade Lock
7. Blade
8. Guard Lock
9. Rear Guard
10. Motor Housing
11. Neck
12. Body
13. Power cord
14. Bellows
ON/OFF: Press once to turn the unit on. Indicator lights will illuminate.
Press the button again, unit will be turned off.
SWING: Press once to engage auto swing. SWING: indicator light will illuminate .Press again for
fixed direction.
SPEED: Press to select fan speed; High-Medium-Low.
MODE: Press the button. Until will operate under irregular status according to pre-set program.
Wind speed can be chosen from High to Low.
TIMER: Press the button to adjust the time 0.5 hours to 7.5 hours.
MIST: Press to turn on the mist. Before using mist function, add water into water tank(pic.1). The
mist can be adjusted by the knob(pic.2)Press the button again ,the humidifier will stop working.
USE
Once finished to assembled, check that the plugs (the one which connect the tank to the fan and the
fan itself) are correctly plugged.
Control panels
Plug the supply cord to the socket.
The red light POWER switch on.
Press ON/SPEED to activate the blades (the red light NORMAL illuminate) and choose speed (the
red light DOWN illuminate); pressing many times ON/SPEED you can choose the airflow speed (for
each press the red light illuminate and indicate the selected speed : MEDIUM and HIGH).
Press SWING to activate the fan swing (the red light SWING illuminate). Press again to switch off
swing (the red light SWING switch off).
Press MIST F to activate the water spray (the blue light MIST switch on). Select ON/OFF on position
I (the green light on the mist button illuminate) and choose the intensity of the water spray (MIN et
MAX) with the handle.
!!IMPORTANT!!: the tank must be full before using the mist function.
After use, press MIN, press ON/OFF position 0 and press MIST (the blue light illuminate).
Press TIMER (when the fan is working) to select timer to switch off the fan (once the time sets the
red light switch on). You can choose program max. until 7hours30, each time you press the button
will set + 30 minutes an the red lights illuminate.
Press OFF to stop air-flow, the red light POWER still lights ; it will completely stop when the supply
15. Button
16. Two Columns
17. Base Cover
18. Weight Base
19. Head for Colum
20. Lead Wire
21. Water Tank Cover
22. Water Tank
23. Atomizer
24. Atomizer Knob
25. Fixed Colum
26. Lock Plate
27. Base Screw
12