ENGLISH
3.2. PRODUCT FEATURES
3.2.1. PARTS DESCRIPTION
1. Probe
2. Probe cover
3. Display LCD
4. ON / OFF Button
5. Battery cover
5
3.3. INSTRUCTIONS FOR USE
1. Ensure that the thermometer has been turned off before taking temperature.
2 Press the power button. A short "Bi" signal will be heard, all the symbols will be turned on for one
second to ensure all parts of the LCD is functioning properly, and then the last measurement data
will be shown on the display for about 2 seconds. Finally, the flashing symbol °C will appear to
indicate that the thermometer is ready to measure the body temperature.
3 During the measurement the LCD will display "Lo °C" if the measured temperature is below
32.0°C, or will display "Hi°C" if the measured temperature is above 43.0°C.
4 When the maximum temperature has been reached or if for 16 seconds no temperature increase
above 0.1°C occurs, the thermometer will have reached thermal equilibrium, °C symbol stops
flashing and the beeper will sound 10 times. The temperature is now ready to read and will not
change when the thermometer is removed.
5 If the measured temperature is higher than 37.8°C, the fever warning function will make the
beeper sound fleetly for about 10 seconds.
6 After measuring, turn off the unit by pressing the power button. If the power is left on, the
"automatic shutoff function" will activate in approx. 9 minutes to save power. In continuous
measurement, start each operation again from the beginning.
Notes:
· The normal temperatures are different depending on the human body and measuring time.
· Wait at least 3 minutes between measurements.
· Measurement may be inaccurate when the battery is low.
· To get stabilize temperature, it is advice to measure for at least 3 minutes.
· Children should be under close supervision at all times while using this product. After monitoring
the temperature, the unit should be removed from the child immediately.
3.3.1. METHODS OF USE
When measuring the body temperature, always take the measurement from the same part of the
body and at the same time of day.
Whichever method is used, it is recommended to avoid eating or drinking any liquids, exercising,
taking showers or baths, or smoking for 15 minutes prior to use.
3.3.1.1. MOUTH (ORAL USE)
1. Cover the thermometer's tip with a probe cover.
2. Place the probe tip well under the tongue. The mouth should remain closed during the
measurement to ensure an accurate reading. Be careful not to bite the thermometer.
12