Countdown Timer; Count Up Timer; Helpful Hints - ThermoPro TP-17 Manual De Instrucciones

Countdown Timer:

Slide the mode selector switch on the back of the device to the timer
position .
The second row of the screen will display the timer information and the
first row of the screen will toggle the display of the temperatures of Probe
1 or 2.
Press ▲/HR to set the hours and ▼/MIN to set the minutes.
EN
Press S/S (start/stop) button to start the countdown timer. The colon
between hours and minutes will flash.
If the setting or the remaining countdown timer is less than 1 hour, the
display will automatically switch to display the minutes and seconds.
When the timer gets to 00:00, the alarm will sound. Press any button to
silence the alarm. The device has a timing memory and will automatically
display the original timer setting when S/S is pressed to silence the
alarm.
To clear the timer setting, press the ▲/HR and ▼/MIN buttons at the
same time. You can pause the timer while it is running by pressing S/S
button. Press S/S button again to restart the timer.
If you are using the timer and thermometer at the same time, you may
slide the selector switch back to the cook position during the timing
session to set or view the cooking temperatures. The timer will continue
the countdown . The alarm will sound when it reaches 00:00 and you can
silence the alarm by pressing any button.

Count up Timer:

Slide the mode selector switch on the back of the device to the timer
position .
-27-
Press the ▲/HR and ▼/MIN buttons at the same time to clear the timer
setting to 00:00.
Press S/S button to start count up timer. Press it again to stop/re-start
the timer.
The timer will stop when it reaches 99 Hour:59 Minute.
If you are using the timer and thermometer at the same time, you may
slide the selector switch back to the cook position during the timing
session to set or view the cooking temperatures. The timer will continue
counting up .
Note: When setting the timer, you can press and hold ▲or▼ for fast setting.

Helpful Hints

If the unit display LLL or HHH instead of the probe temperature, wait for
probe to reach room temperature. If LLL or HHH is still displayed it is likely
the internal probe wire has shorted out either through moisture or heat
damage.
Do not immerse the probe in water while cleaning.
Do not allow the probe or probe wire to come into contact with flames.
Within the warranty period, return defective probe to address below
along with return address and we will send you a replacement probe at
no charge.
If the temperature displayed seems to read too high or the temperature
seems to increase too quickly, check to make sure the probe tip is not
poking through the food to outside. Reposition the probe tip in the center
of the thickest part of food. Avoid touching bone or heavy fat areas.
-28-
EN