Descargar Imprimir esta página

Notes On Repainting; Caution - Arai Helmet Urban-V Instrucciones De Operación

Publicidad

8
English

NOTES ON REPAINTING

If painting your helmet, make sure to protect the entire inside of the
helmet from the paint spray by masking all openings with paper and
tape as paint can adversely effect the EPS (a.k.a. Styrofoam) shock
absorbing liner and plastic components. Use only air-drying paint, not
paints that require heat curing. Do not remove any permanent Arai helmet
components, such as the EPS liner, chinstraps, mounting rivets/bolts or
non-removable interior comfort linings, to paint an Arai helmet or for any
other reason.

CAUTION

As is the nature of a good helmet, your helmet is so constructed that the
energy of a severe impact is absorbed through partial destruction of the
shell and/or liner. Such damage may not be visible to the naked eye. If the
helmet suffers such an impact and any doubt exists as to its further ability
to protect, it should either be returned the manufacturer for competent
inspection or discarded and replaced by a new Arai helmet. Check your
helmet every time before use for damage and do not use a damaged
helmet. Any helmet, like all products may wear out over time depending
upon its use and the amount of care that it is given. Arai recommends you
discontinue the use of this helmet no more than five years after first use,
even if the helmet does not show a malfunction or any visible damage or
defect.

Publicidad

loading