Cleaning And Maintenance - Proline VT23 Manual De Instrucciones

Make sure that the holes in both guards are aligned and fasten
them securely by using the provided screw and nut. Once the
guard is in position fasten the clips to finally secure both guards.
OPERATION
1.Place the fan on a stable, level surface.
2.Plug the fan in the mains socket.
3.Press the 1 or 2 control button to select the desired speed. To
turn off the fan, press the 0 control button.
0= Off 1= Low speed 2=High speed
4.To make the fan oscillate, push down the oscillation knob
located on the top of the motor housing and the fan will
oscillate from side to side.
To stop the fan from oscillating, lift up the oscillation knob.
5.Tilting Adjustment
While holding the base loosen the adjusting knob to adjust the
fan head to the desired position and then tighten the adjusting
knob.

CLEANING AND MAINTENANCE

Always unplug the fan from the mains socket before cleaning.
Once the fan is assembled, it is forbidden to disassemble the
grids (guard) when cleaning.
Clean the fan with a slightly damp cloth, and then dry it.
EG-5
6