Binding - Spectrum DX8G2 Manual De Instrucciones

BINDING

F
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter.
You must bind the AR8000 receiver to your transmitter before it will operate. The AR8000 requires the remote receiver to be connected to bind.
Binding Using the Receiver and Receiver Battery
1
F
4
F
1. Lower throttle to the lowest position and make sure the
transmitter is powered off. F
2. Insert the bind plug into the BIND/DATA port.
3. Insert the receiver battery into ANY open port. The receiver's
LED will flash when the receiver is ready to bind.
F
4. While pressing the Bind button, power on the transmitter.
Binding Using the Receiver and ESC
1
F
5
F
1. Lower the throttle to the lowest position and make sure the
F
transmitter is powered off.
2. Insert the bind plug into the BIND/DATA port.
3. Insert the ESC plug into the THRO port.
4. Connect the battery to ESC and turn on the ESC switch,
if available. The receiver's LED will flash rapidly when the
receiver is ready to bind.
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL
2 3
5 6
2 3
6 7
5. Release the Bind button after the receiver has stopped
flashing rapidly, once the receiver's LED stays illuminated;
this indicates the receiver is bound to the transmitter. The
transmitter screen also provides binding information.
6. Remove the bind plug from the receiver.
4
5. While pressing the Bind button, power on the transmitter.
6. Release the Bind button after the receiver's LED stays illumi-
nated. This indicates the receiver is bound to the transmitter.
The transmitter screen also provides binding information.
7. Remove the bind plug from the receiver.
EN
11