Adjusting The Elevator Centering Screw; Moving The Throttle Limiting Wedges; Re-Assembling The Transmitter - Spectrum DX8G2 Manual De Instrucciones

PHYSICAL TRANSMITTER ADjUSTMENTS

Adjusting the Elevator Centering Screw

When changing between Modes 1 and 2, or between Modes 3 and
4, you must adjust the elevator centering screw.
1. Hold the Elevator or Throttle stick in the full up or full down
position when you are adjusting the elevator centering screw.
Holding the gimbal stick reduces the load on the elevator
centering mechanism and makes it easier to adjust the
centering screw.
2. Locate the gimbal where the elevator centering spring is
engaged. Use a Phillips screwdriver to tighten the elevator
centering screw. Tightening the screw will disengage the
centering spring.
3. Using a Phillips screwdriver, loosen the opposite elevator
centering screw until the lever engages.

Moving the Throttle Limiting Wedges

Throttle limiting wedges are used to limit the maximum throttle
travel. When changing between Modes 1 and 2, or between Modes
3 and 4, you must move the throttle limit wedges.
1. Move the gimbals a small amount to remove a screw and
wedge from the top and bottom of the throttle gimbal.
2. Install the wedges on the other gimbal using two screws.

Re-assembling the Transmitter

1. Put the rear of the transmitter case on the main case, taking
care to not pinch any wires.
2. Install and tighten the eight Phillips screws.
3. Reinstall the battery holder or optional battery.
4. Power on the transmitter. When a calibration screen shows,
move the control sticks to extremes and to centers as directed
to correctly calibrate controls.
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL
EN
47