Speed; Balance; As3X Gain Live View (Acro And Sail Types Only) - Spectrum DX8G2 Manual De Instrucciones

EN
FUNCTION LIST
 Speed
The Speed menu enables you to slow the response time on any
individual channel (such as retracts).
The Speed is adjustable in the following ranges:
• Nor (No Delay) – 0.9s in 0.1 second increments
• 1s – 2s in 0.2-second increments
• 2s – 8s in 1-second increments
 Balance
Balance is available on all channels to fine-tune the servo position
at up to 7 points. This is a precision curve mix that is normally
used to prevent binding when multiple servos are used on a single
control surface.
You can also use the Balance menu option to match throttle
response on twin engine aircraft or level the swashplate on a
helicopter.
 AS3x Gain Live View (ACRO and SAIL Types only)
When using a compatible AS3X receiver (AR636, AR6335,
AR9350, etc.), Gain Live View allows
• Real time display of gain values for Roll Pitch and Yaw
• Allows gains to be adjusted from the roller
• Selection of the channel that is used to adjust gains (must match
application)
• Selection of the switch that is used to change flight modes
To activate AS3X gain Live View:
1. In the telemetry screen in one of the empty positions select
AS3X and activate the Display. This will activate the AS3X Gain
menu in the Function List.
2. In the Function List Access the AS3X Gain menu. If an AS3X
receiver is bound to the transmitter and the receiver and
transmitter are on, live gain values will be displayed on this
screen.
32
To adjust the Speed:
1. Scroll to the channel
you wish to adjust
and press the scroll
wheel.
2. Scroll left or right
to adjust the speed
and press the scroll
wheel to save the
selection.
Axis: R oll Pitch and Yaw gain are displayed to the right of each Axis
Rate: Rate gain values are displayed here
Heading: Heading gain values are displayed here
Actual: The current gain value is displayed here. Note that this value
takes into account the priority gain and the stick position of
that channel
Gain: This value represents the position of the input (roller or knob)
Input: Allows the selection of the roller to be used to adjust the gain
Channel: Must correspond to the channel selected in the AS3X
application in the FM Channel Assignment screen
FM Switch: Selects the switch on the transmitter that is used to
select the flight modes in the AS3X system
Note that relative (REL) must be selected in the application's gain
screen to allow adjustable gain from the transmitter.
Please see the following web address for videos and information
about setting up the AS3X application, Live View and adjusting the
gain from the transmitter.
http://www.spektrumrc.com/Technology/AS3X.aspx
SPEKTRUM DX8G2 • TRANSMITTER INSTRUCTION MANUAL