Charging Time - Holmatro BCH1 Manual Del Usuario

Ocultar thumbs Ver también para BCH1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 60
EN
Slide the battery pack into the adapter until the battery pack lock snaps tight.
The green LED on the right part of the condition indicator label will light up, to indicate that the
battery pack is being charged.
NOTE
The maximum capacity of the battery pack is only achieved once it has been charged
and discharged several times.
The battery pack can remain connected to the battery charger for an indefinite period of
time, because it is protected against overcharging.
When the battery pack is not in use, it is advised to keep it connected to the battery
charger (connected to a power source) at all times. When the battery pack is full, the
battery charger automatically switches on and off at regular intervals to keep the battery
level at 100%.
After deep discharge of the battery pack, charge the battery pack for 24 hours. If the
battery pack is not completely charged after 24 hours, contact your local Holmatro
dealer.
5.2

Charging time

The charging time depends on several factors, such as:
the discharge state of the battery pack
the ambient temperature during charging
the temperature of the battery pack
the age of the battery pack
A new battery pack or a battery pack that has not been used for a long time will only achievefull power
after approx. 5 charging and discharging cycles. The table below shows the average charging times (at
a temperature between 18 °C and 24 °C [64 °F and 75 °F])
/i
Battery pack model
BPA283
BPA284
BPA285
5.3
After use
Check the battery charger for completeness and damage. Do not use the battery charger if it is
damaged; in that case contact the Holmatro dealer.
If necessary, clean the battery charger.
A battery charger that has not been mounted as described in section 4.1, must be carefully stored.
See the instructions in section 7.5.
6
Troubleshooting
6.1
General
Consult the Holmatro dealer if the listed solutions do not give the desired result, or in case of other
problems. For malfunctions or repair, always specify the model and serial number of the equipment.
28
Average charging time - BCH1 / BCH2
45 min
60 min
75 min
916.001.320_006
Average charging time - BCH3
90 min
120 min
150 min
BCH1 / BCH2 / BCH3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Bch2Bch3

Tabla de contenido