Operating Manual; Operating Element; Lifting The Vehicle; Lowering The Vehicle - Nussbaum JUMBO LIFT 3500 NT Instrucciones De Servicio

5

Operating manual

When handling the system, it must
absolutely comply with safety regula-
tions. Carefully read the safety regu-
lations in Section 3 before first opera-
tion!
5.1

Operating element

4
1
1 Main switch
o
2 „Lift" button
u
3 „Lower" button
X-TEND
2
3
4
Operating lever
1 Lift + Press = LIFT
2 Home position
3 Lift + Pull = LOWER
OPI_JUMBO LIFT 3500 NT_V3.1_DE-EN-FR-ES-IT
2
3
003
4 CE-Stop button
1
4
Operating elements
4 CE-Stop button
5.2

Lifting the vehicle

• Drive the vehicle over the drive rails lengthwise
and cross-wise in the centre.
• When driving onto the lift, position the ramps so
that the rollers (7) of the ramps (9) are on the
ground.
9
7
7 Rollers
8 Supports
9 Ramps
Otherwise the supports (8) and ramps (9) can be
damaged.
• Secure the vehicle against rolling. Apply the
handbrake, put into gear.
• Position polymer overlays below the receiving
points approved by the vehicle manufacturer.
i If required, use the ramps for safe acceptance
of the vehicle. If the wheel base is too short, fold
the ramps underneath.
To receive the vehicle, the polymer
overlays cannot be placed on edge
otherwise there is a danger of the car
falling.
• Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
• Switch on controls. Turn the main switch (1) to po-
sition „1" (see figure 003).
• Lift the vehicle. Push the
• X-TEND: Lift the vehicle. Activate the
ating lever.
• If the wheels are not blocked, interrupt the lifting
process and check for proper seating of the poly-
mer overlays.
• Raise the vehicle to the desired working height.
Push the „Lift" (2) button.
o
• X-TEND: Raise the vehicle to the desired working
height. Pull the o "Lift" operating lever.
5.3

Lowering the vehicle

• Inspect the hazardous area.
No person or object may stand in the working
area of the lift, or on the lift.
The vehicles cannot be lowered into the lowest
!
position without wheels. Otherwise the lift can-
not raise the load using its own force. The vehi-
cle could be damaged.
8
004
„Lift" (2) button.
o
"Lift" oper-
o
71