Description; Accessories - Hilti SFL 144-A Manual De Instrucciones

Symbols
Read the Volts
operating
instructions
before use.

2 Description

2.1 Use of the product as directed
The appliance is designed to be used as a source of light on construction sites.
The appliance is manufactured from high-grade, impact-resistant plastic. The battery and charger are not supplied
with the lamp.
Use only the specified type of replacement bulb.
Keep the appliance out of reach of children.
Take the influences of the surrounding area into account. Do not use the power tool or appliance where there is a risk
of fire or explosion.
The appliance may be used only in a dry environment.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
To avoid the risk of injury, use only genuine Hilti tools and accessories.
Modification of the appliance or tampering with its parts is not permissible.
2.2 Li‑ion battery charge status
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
-

3 Accessories

Designation
Charger for Li-ion batteries
Battery
Replacement bulb
Reflector
Return waste
material for
recycling.
LEDs blink
-
-
-
-
LED 1
LED 1
Location of identification data on the appliance
The type designation and serial number can be found
on the type identification plate on the appliance. Make
a note of this data in your operating instructions and
always refer to it when making an enquiry to your Hilti
representative or service department.
Type:
Generation: 01
Serial no.:
Charge status C
C ≧ 75 %
50 % ≦ C < 75 %
25 % ≦ C < 50 %
10 % ≦ C < 25 %
C < 10 %
Battery overheated
Short designation
C 4/36, C 4/36‑ACS or C 4/36‑ACS TPS
B 144/2.6 Li‑ion
Xenon 14.4V/ 0.8A
For the SFL 144-A
en
9