Connecting Electrical Appliances; Switching On The Vacuum Cleaner; Switch Position "I; Switch Position „Auto - Makita 447 M Instrucciones De Manejo

MAKITA 447 M
4.1.3 Connecting electrical
english
appliances
4.2 Switching on the
vacuum cleaner

4.2.1 Switch position "I"

The hose diameter and the setting
for the suction hose diameter must
be the same.
Hose
ø
ø27
ø32
ø36
ø50
4.2.2 Switch position „auto"
The hose diameter and the setting
for the suction hose diameter must
be the same.
Hose
ø
ø27
ø32
ø36
ø50

4.2.3 Suction power control

4.3 Check volume flow
monitor
6
To comply with regulations, only ap-
proved dust producing tools should
be connected.
The maximum power consumption
of the connected power tool is stat-
ed in section 9.4 "Technical data".
Hose diameter
setting
ø27
ø32
ø36
ø50
Hose diameter
setting
ø27
ø32
ø36
ø50
Before picking up dust with maxi-
mum room concentration values:
1. Ensure that the electrical
appliance is switched off.
2. Connect the electrical appli-
ance to the appliance socket
on the control panel.
1. Turn the switch to position „I".
The vacuum cleaner motor
starts.
0
auto I
Before switching the switch to position
„auto", ensure that the tool connected
to the appliance socket is switched off.
0
1. Turn the switch to position
auto I
„auto". The vacuum cleaner mo-
tor starts when the connected
appliance is switched on.
2. When the power tool is switched
off the vacuum cleaner contin-
ues to run for a short moment so
that any dust in the suction hose
is conveyed to the safety filter
bag.
The motor speed and the suc-
tion power can be varied with
the suction power control. This
allows precise adaptation of
0
the suction power for different
I
auto
cleaning tasks.
1. Check that all the filters are
present and properly fitted.
2. When the motor is running,
hold the suction hose shut.
An acoustic warning sounds
after approx. 1 second.