Emergency Stop - Briggs & Stratton Allmand NIGHT-LITE GR Serie Manual Del Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

19
Auxiliary AC Outlet
An auxiliary AC outlet (B, Figure 20) is located on the right
side of the control panel. The outlet is protected by a spring-
loaded cover.
Power is supplied to the outlet only when the engine is
running and the main circuit breaker (A, Figure 20) is in the
ON position.
Note: The electrical system is designed with a delay after
the engine starts before the lights and auxiliary AC outlet will
operate.
The outlet is protected by a dedicated circuit breaker (C,
Figure 20) found on the control panel.
If a breaker trips
1. Disconnect the load from the outlet.
2. Shut down the engine.
3. Wait 10 minutes for the generator to cool down.
4. Correct the load problem.
5. Start the engine.
6. Reset the breaker.
Note: Be sure to also check the GFCI breaker on the GFCI
outlet, and reset if necessary.
7. Reconnect the load.
8. If the problem persists, see Troubleshooting.
20
Unit Shutdown
WARNING
Do not remove the wheel chocks from the front and back
of the wheels until the light tower trailer is connected to the
tow vehicle and ready to be transported. Doing so could
result in death or serious injury.
Once lighting operations are complete at the work site, shut
down the unit:
1. Shut down the engine. See Operating the Engine.
2. Wait 10 minutes for the lights to cool.
3. Lower the light tower. See Raising And Lowering the
Light Tower.
4. Rotate the light tower to the transport position. See
Adjusting the Lights.
5. Adjust the light fixtures to the transport position. See
Adjusting the Lights.
6. Make sure the engine compartment cover is closed and
latched.
7. Retract the outriggers. See Leveling and Stabilizing the
Light Tower Trailer.
The unit is now ready for transport. See Transporting.

Emergency Stop

The unit has an emergency stop that will immediately shut the
entire unit down in case of an emergency.
To engage:
• Push the emergency stop (A, Figure 21).
To disengage:
• Pull the emergency stop.
Make sure that you address the issue that caused the
emergency before you operate the unit again.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido