Operating Guide; Application Method - Drive Handy-Ox Instrucciones Para Su Uso

6 OPerAtInG GuIDe

6.1 Application Method

A. Measuring the data
a) Open the lid of battery box and put the battery inside, then close.
b) Put the fingertip probe into the jack on the underside of the oximeter. Only use Drive Medical
supplied accessories.
c) Put the finger into the probe.
d) Press and hold the "power on/off button" for a few seconds. The device will power on within a
few seconds and will start to self-check. The device displays the user interface after self-check.
e) Do not shake the finger and keep the patient in a calm state during measurement.
f) The data can be read directly from the screen in the user interface.
Fingernails and the luminescent tube should be at the same side.
If the alarm function is on, the device will provide a medium priority alarm signal when the
probe plug or finger is out. An intermittent alarm will occur and the user interface presents
"FInGer Out".
Medium priority indicates that prompt operator response is required.
16
English