Num'axes EASY DOG SOFT Manual De Instrucciones página 24

Place these 2 areas
together during 1 second
Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the
receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding (fi rst use of the collar or re-coding), make sure no other
person is using his EASY DOG or other products from the NUM'AXES range close by: your receiver collar
could accidentally record the code of his remote control. If that occurs, re-code the remote control with
the receiver collar.
CODING PROCEDURE FOR THE 1ST USE
1 To begin the coding procedure, the remote control must be ready for use (battery in its housing).
2 Activate the collar: move the remote control towards the collar so that the round mark on the remote
control comes into contact with the white mark on the collar, hold for 1 second.
3 Move the remote control away from the receiver collar.
4 Press the button of the remote control. A beep sound is emitted; the collar is then synchronized with
your remote control.
RE-CODING PROCEDURE (for all coding procedures other than the 1st)
1 To begin the re-coding procedure, the remote control must be ready for use (battery in its housing).
2 Collar in position "deactivated" (indicator light off): move the remote control towards the collar so that
the round mark on the remote control comes into contact with the white mark on the collar, hold for 6
seconds. The indicator on the collar lights in fi xed green, then fl ashes in red.
3 Move the remote control away from the receiver collar.
4 Press the button of the remote control. A beep sound is emitted; the collar is then synchronized with
your remote control.
Gb - 24
Diagram 6
Activate/Deactivate a receiver
collar with an EASY DOG SOFT
or EASY DOG PULSE remote
control