I
ENGLISH
INSTRUCTION MANUAL
D) USING THE CHRONOGRAPH
The chronograph function of this watch is able to measure and display elapsed time up to 59 minutes 59 seconds in 1
second units. After the chronograph displays elapsed time for 59 minutes 59 seconds, it resumes timing from 0 seconds. The
chronograph minute hand continues to move until the chronograph is stopped by pressing button (A) even after 59 minutes 59
seconds have elapsed.
Chronograph Timing
1. Start timing by pressing button (A).
* The chronograph is repeatedly started and stopped by pressing button (A).
2. Pressing button (B) resets the chronograph to 0 seconds.
RESET
E) ZERO POSITIONING OF CHRONOGRAPH HANDS (after replacing the battery)
When resetting the chronograph after replacing the battery, if the chronograph second hand does not return to the 0 seconds
position or if the chronograph second hand has shifted out of position due to a strong impact, perform zero positioning of the
chronograph hands according to the procedure described below.
Chronograph Hand Zero Positioning
1. Pull the crown out to the time correction position.
2. Press button (A) to position the chronograph second at the 0 position.
* The chronograph second hand can be advanced rapidly by depressing button (A) continuously.
3. Once the chronograph second hand has been positioned at the 0 position, reset the time and return the crown to the
normal position.
4. Press button (B) to check that each of the chronograph hands has been reset to the 0 position.
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making
products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other
authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and
protecting our health.
TIME MEASUREMENT
IFMFS60/61
STOP