Using The Chronograph; Chronograph Reset (Incl. After Replacing Battery) - Festina IFMOS25 Manual De Instrucciones

USING THE CHRONOGRAPH

This chronograph is able to measure and display time in 1/20 second united up to
maximum of 59min 59sec. The retrograde chronograph 1/20(1/1) second hand keeps
continuously for 30 seconds after starting, and then stops at ZERO position.
[Measuring time with the chronograph]
1. Press button "B" to change the watch to the chronograph mode. The second hand
stops at the ZERO second position, and changes to the chronograph 1/20(1/1)
second hand.
2. The chronograph can be started and stopped each time button "A" is pressed.
3. Pressing button "B" resets the chronograph and all hands return to their 0
positions.
RESET
MEASUREMENT
IFM0S25 IFM0S25
TIME
STOP
14
IFM0S25
CHRONOGRAPH RESET
(incl. After replacing battery)
This procedure should be performed when the chronograph second hand does not
return to the "ZERO" second position after the chronograph has been reset, and
including after the battery has been replaced.
1. Pull the crown out to the 2nd Click Position.
2. Press button "A" to set the chronograph second hand to the 0 position.
3. Press button "B" to set the chronograph 1/20 second hand to ZERO
position.
4. The chronograph hands can be advanced rapidly by continuously pressing
button "A" or "B".
5. Once the hands have been zeroed, reset the time and return the crown to
its normal position.
Do not return crown to normal position while chronograph second hand
*
return to 12:00 (ZERO) position. Hand stops on the way when crown are
returned to normal position and these positions are recognized as 12:00
(ZERO) position.
15