Operation - Vortice Air Door H Serie Manual De Instrucciones

ENGLISH
B Mounting on wooden walls
Fix the mounting plate in the right position using
threaded screws (fig.12).
12 12
Vite per legno
Piastra di montaggio
Apply the central body as described before (fig.13).
13 13
C Mounting above the ceiling (false ceiling)
Fix the air curtain in place using the same
installation procedure as for concrete walls.
Connect the pipes as shown in the fig.14.
14 14
Air duct
Ceiling
NOTE: if mounting above the ceiling, appliance
performance could vary with respect to the stated
values.
12
In
Out
Operation (with remote control)
• Press ON/OFF to switch the
appliance on/off.
• When you turn on the
appliance, it starts in cold air
operating mode, at max
speed.
• After activating
appliance, adjust the air
outlet grille to direct the jet of
air as desired.
• Press POWER repeatedly to
switch from cold or warm air
operating mode,
different values of power (I/II/III, see Table)
HEATER POWER (KW)
MODEL
I
AD900 M 2
AD900 T 2
AD1200 T 2,7
3,3
AD1500 T
• Press SPEED repeatedly to switch from low speed
to high speed in cold or warm air operating mode.
• If the appliance has been running in warm air mode
for at least 1 minute, when it is switched off using the
ON/OFF button it will run in cool air mode for 3
minutes before switching off automatically.
Connection case to door opening sensors
• The product starts to operate when the door is
opened and the sensor terminals lose contact.
(Fig.16); When the door closes and the two
terminals are in contact again the product will stop to
operate (fig.17).
ON
16 16
1
15 15
ON/OFF
SPEED
the
POWER
with
II III
4 6
4 6
5,3 8
6,7 10
1