Charging Battery; Battery Protective Maintenance - Starblitz ASPIC Manual De Usuario

EN

Charging battery

1. AC charge: Battery charger is developed for international use within the range of
FR
AC 100-240V. Insert 5.5mm round terminal into charging socket of the battery, and
insert the other end of the charger to a grounded outlet(Fig6). When the unit is in
charging, LED indicator on the charge lights up red. When the unit is fully charged,
LED indicator on the charge lights up green. A fully exhausted battery reaches full
ES
power after 5 hours' charging. Depending on the battery condition, charging hours
may change.
2. 12V DC Outlet Charge: Use car charger adapter. Insert small terminal into char-
ging socket of the battery, and plug the other end of the charger into to a vehicle's
12V outlet (Fig. 7).
 Please remove plug from source supply after the battery is fully charged.

Battery protective maintenance

1. Charge the battery fully before using the unit for the first time.
2. If leave battery in studio flash, it will be consumed even without use. To prevent
battery from excessive discharge, after you finished use the studio flash or before you
store the studio flash, please switch off the unit and remove battery.
3. The battery itself consume during stock, to keep good performance of battery and
avoid exhausted, always charge battery from stock at least every three month.
4. Do not drop the batteries onto hard surfaces, as this could expose the corrosive
materials inside the battery case.
5. Do not attempt to incinerate Lithium batteries or expose them to excessive heat.
Batteries can explode if you toss them into a fire or place them near other extreme
heat sources.
6. Charging times and numbers of flashes may vary according to the condition of the
battery.
10
(Fig. 6) (Fig. 7)