Starblitz ASPIC Manual De Usuario página 23

3. Install New Flash Tube
Make sure the power switch is OFF and the flash is without battery on it.
3-1. Align the pins on the flash tube with the pin receptacles. Push the pins into the
receptacles using firm, even pressure at the base of the flashtube (Fig. 14).
3-2. Wrap wire on hook (Fig. 15).
3-3. Wrap wire around flash tube for one circle (Fig. 16).
3-4. Wrap wire on hook again. With needle-nose pliers, gently pull the wire upward
until tighten (Fig. 17).
3-5. With needle-nose pliers, cover retention spring over the wire, and hook the re-
tention spring loop at the top of the flash tube (Fig. 18 & 19).
(Fig. 14)
(Fig. 17)
(Fig. 15)
(Fig. 18)
(Fig. 16)
(Fig. 19)
EN
FR
ES
21