Sewing On Buttons (Model 3221) - Singer 3221 Manual De Instrucciones

Sewing on Buttons (Model 3221)

EN
Install the darning plate. (1)
Change the all purpose foot to button sewing foot. (2)
Position the work under the foot.
Place the button in the desired position and lower the foot.
Set the pattern selector dial on " " and sew a few securing
stitches. Select one of the two narrow zig-zag patterns
according to the distance between the two holes of the
button. Turn the handwheel to check if the needle goes into
the right and the left hole of the button without hitting the
button. Slowly sew on the button with about 10 stitches.
Select pattern " " and sew a few securing stitches. (3)
1 2
If a shank is required, place a darning needle on top of the
button and sew. (4)
For buttons with 4 holes, sew through the front two holes first,
push the work forward and then sew through the back two
holes.
4
3
37