Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cod. 97841 V06_17
Configuration of channels and groups (see table Configuration channels and groups)
Use the button (4) to configure the activator's operating mode.
Channel configuration: Keep the configuration button pressed down until the number of long red signals is equal to
the channel to be configured. For example, if you want to configure channel 2, release the button after the second
long red signal.
Group configuration: Press the configuration button and keep it pressed down. The led will issue the red channel
configuration signals followed by a series of flashing green signals to indicate that the open group will start the group
selection sequence (long green signals
indicating groups 1 to 7). Release the button at the required group. For example, if you want to configure group 5,
release the button after the fifth long green signal.
Sequence for configuring channels and groups (e.g. channel 2, group 5)
Cod. 97841 V06_17
Configuration of channels and groups (see table Configuration channels and groups)
Use the button (4) to configure the activator's operating mode.
Channel configuration: Keep the configuration button pressed down until the number of long red signals is equal to
the channel to be configured. For example, if you want to configure channel 2, release the button after the second
long red signal.
Group configuration: Press the configuration button and keep it pressed down. The led will issue the red channel
configuration signals followed by a series of flashing green signals to indicate that the open group will start the group
selection sequence (long green signals
indicating groups 1 to 7). Release the button at the required group. For example, if you want to configure group 5,
release the button after the fifth long green signal.
Sequence for configuring channels and groups (e.g. channel 2, group 5)
4
4
3200286
3200286
Publicidad
Tabla de contenido
