Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Cod. 97841 V06_17
Starting up
Installation
The activator is formed by two parts: a compact box (1) with a plastic front part and the wiring outlet at the back and
an adhesive trim (2). It is designed to be fitted directly to or built into the wall. It is secured by two
screws (3), separated by 60mm (ideal separation if it is
built-into a standard plug or socket box). The adhesive is fitted over Position 2 in the Figure, ensuring
that the led (5) is visible through the adhesive window. Before fitting the adhesive, screw in and
configure the activator.
N.B.: The activator should not be installed on metal surfaces, as this may reduce the enabling area.
Cod. 97841 V06_17
Starting up
Installation
The activator is formed by two parts: a compact box (1) with a plastic front part and the wiring outlet at the back and
an adhesive trim (2). It is designed to be fitted directly to or built into the wall. It is secured by two
screws (3), separated by 60mm (ideal separation if it is
built-into a standard plug or socket box). The adhesive is fitted over Position 2 in the Figure, ensuring
that the led (5) is visible through the adhesive window. Before fitting the adhesive, screw in and
configure the activator.
N.B.: The activator should not be installed on metal surfaces, as this may reduce the enabling area.
3
3
3200286
3200286
Publicidad
Tabla de contenido
