Proper Use - EINHELL AG 7,2 Manual De Instrucciones

GB

3. Proper use

The AG 7.2 and AG 7.2 FG cordless grass cutters
are designed for cutting the edges of lawns and
small areas of grass in private and hobby gardens.
Tools for private and hobby gardens are not suitable
for use in public facilities, parks and sport centers,
along roadways, on farms or in the forestry sector.
For the tool to be used properly it is imperative to
follow the instructions set out in the manufacturer's
directions for use.
Important!
It is prohibited to use the tool to cut hedges or to
chop material for composting because of the
potential danger to persons and property.
4. Layout of the AG 7.2 (FG)
(see picture on page 3)
1 cutter blades
2 safety lock-off
3 battery compartment lid
4 ON button
5 telescopic handle (only for the AG 7.2 FG)
6 clamp coupling (only for the AG 7.2 FG)
7 knurled screws (only for the AG 7.2 FG)
8 wheels (only for the AG 7.2 FG)
5. Technical data of the AG 7.2 (FG)
Cutting width
Running time approx. 70 min.
Cutting capacity approx. 800 m
NC battery pack 7.2 V / 1200 mAh
Charging supply unit
Voltage: 230V ~ 50 Hz
Output
Nominal voltage:
Nominal current: 200 mA
Nominal power:
8
6. Starting up
Charging the NC battery pack
1. Open the battery compartment lid and remove
the battery pack from the handle.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Connect the charging cable to the
charging adapter and plug the battery charger in
a socket-outlet. The green LED on the charging
adapter comes on to indicate that charging
voltage is available.
3. Insert the battery pack in the charging adapter.
The red LED comes on to indicate that the
battery is being charged. An empty battery
requires a maximum charging period of 8 hours.
The temperature of the battery may rise slightly
during the charging operation. This is normal.
N.B.: There is no automatic switch-off when
the battery is fully charged.
If the battery fails to charge, please check
- whether there is voltage at the socket-outlet
- whether there is good contact at the charging
contacts of the battery charger.
If you still fail to charge the battery, please return
the power supply unit
the charging adapter
and the battery pack
to our Customer Service Center.
Timely recharging of the NC battery pack will help it
70 mm
serve you well for a long time. Recharging is always
necessary when you notice a drop in the tool's
performance.
Never allow the battery to become fully discharged.
The results will be a defective NC battery pack!
Operation
First clear away any stones or other solid objects
from where you want to cut. The safety lock-off
12 V
prevents the cordless grass cutter being switched on
accidentally. To switch on the tool you must first
2.4 VA release the safety lock-off by sliding it forward. Then
press the ON button. To switch off, simply let go of
the ON button. When you have finished your work,
slide the black blade guard over the blades.