Assembly And Starting - Parkside EURO 270/8/24 Manual De Instrucciones

Anleitung_Euro_270_8_24_mehrspr:_

6. Assembly and starting

Important!
You must fully assemble the appliance
before using it for the first time.
6.1 Fitting the wheels (3)
Fit the supplied wheels as shown in Fig. 4.
6.2 Fitting the supporting foot (17)
Fit the supplied rubber stopper as shown in
Fig. 5.
6.3 Fitting the air filter (1)
Remove all the transportation stops (Fig. 6)
with a screwdriver or similar and fasten the air
filter (1) securely to the appliance with the
screws (Fig. 7).
6.4 Replacing the oil sealing plug (13)
Remove the transportation cover from the oil
filler opening (Fig. 8) with a screwdriver and
insert the supplied sealing plug (13) into the oil
filler opening (Fig. 9).
6.5 Voltage
The compressor is equipped with a mains
cable with shock-proof plug. This can be
connected to any 230V ~ 50Hz shock-proof
socket which is protected by a 16 A fuse.
Before you use the machine, make sure that
the mains voltage complies with the
specifications on the rating plate. Long supply
cables, extensions, cable reels etc. cause a
drop in voltage and can impede motor start-up.
In the case of low temperatures below +5°C,
motor start-up is jeopardized as a result of
stiffness.
6.5.1 Special connection conditions
The product meets the requirements of EN
61000-3-11 and is subject to special
connection conditions. This means that use
of the product at any freely selectable
connection point is not allowed.
Given unfavorable conditions in the power
supply the product can cause the voltage to
fluctuate temporarily.
The product is intended solely for use at
connection points that
08.06.2007 9:58 Uhr Seite 21
a) do not exceed a maximum permitted
supply impedance "Z", or
b) have a continuous current-carrying
capacity of the mains of at least 100 A per
phase.
As the user, you are required to ensure, in
consultation with your electric power
company if necessary, that the connection
point at which you wish to operate the
product meets one of the two requirements,
a) or b), named above.
6.6 ON/OFF switch (12)
To switch on the compressor, pull out the red
knob (12). To switch off the compressor, press
the red knob (12) in again. (Fig. 1/2)
6.7 Quick-release coupling (6/8)
Connect
Push the nipple on your compressed air hose
into the quick-release coupling, the sleeve will
automatically spring forwards.
Disconnect
Pull back the sleeve and remove the hose.
Important. As you release the hose
coupling, hold the hose coupling part in
your hand to prevent injuries caused by the
hose being thrown backwards.
6.8 Adjusting the pressure: (Fig. 3)
You can adjust the pressure on the
pressure gauge (14) using the pressure
regulator (7).
The set pressure can be taken from the
quick-lock coupling (8).
The tank pressure can be read on the
pressure gauge (9).
The tank pressure can be taken from the
quick-lock coupling (6).
6.9 Setting the pressure switch (10)
The pressure switch is set at the factory.
Switch-on pressure 6 bar
Switch-off pressure 8 bar
GB
21