LaserLiner SmartCross-Laser Manual De Instrucciones página 6

The transport restraint must be released for horizontal and vertical
levelling. The LED (2) shows a permanent green light. The laser lines
!
flash and the LED (2) lights red as soon as the device is outside the
automatic levelling range of 5°. Position the device such that it is
within the levelling range. The LED (2) switches back to green and
the laser lines stop flashing (steady light).
3
Slope mode
LASER LASER
Do not release the transport restraint, set the ON/OFF switch to „OFF". Select
and switch on the laser with the selection button. Sloping planes can now be
measured. This mode cannot be used to perform horizontal or vertical levelling
as the laser lines are no longer aligned automatically. The LED (2) lights
constantly red.
4 Hand receiver mode
Optional: Working with the laser receiver RX
Use an RX laser receiver (optional) to carry out
levelling at great distances or when the laser
lines are no longer visible. To work with a laser
receiver, switch the line laser to hand-held
receiver mode by keeping button 1 (handheld
receiver mode on / off) pressed. The laser lines
will now pulsate with high frequency, making
the laser lines darker. The laser receiver can
detect these pulsating laser lines.
!
Observe the laser receiver's operating instructions for line lasers.
Preparing the calibration check
It is possible for you to check the calibration of the laser. To do this, position the
device midway between 2 walls, which must be at least 5 metres apart. Switch
the device on (LASER CROSS ON). The best calibration results are achieved if
the device is mounted on a tripod.
1. Mark point A1 on the wall.
2. Turn the device through 180° and mark point A2.
You now have a horizontal reference between points A1 and A2.
1.
A1
2.
Performing the calibration check
3. Position the device as near as possible to the wall at the height of point A1.
4. Turn the device through 180° and mark point A3. The
difference between points A2 and A3 is the tolerance.
3.
A1
4.
! When A2 and A3 are more than 0.5 mm / m apart, an adjustment is
necessary. Contact your authorised dealer or else the UMAREX-
LASERLINER Service Department.
06
EN
LASER LASER
A2
A3
LASER
A2
A2
A2
A3