LaserLiner SmartCross-Laser Manual De Instrucciones página 7

Checking the vertical line
Position the device about 5 m from a wall. Fix a plumb bob with a line of 2.5
m length on the wall, making sure that the bob can swing freely. Switch on the
device and align the vertical laser to the plumb line. The precision is within the
specified tolerance if the deviation between the laser line and the plumb line is
not greater than ± 2.5 mm.
Checking the horizontal line
Position the device about 5 m from a wall and
switch on the cross laser. Mark point B on the
wall. Turn the laser cross approx. 2.5 m to the
right and mark point C. Check whether the
horizontal line from point C is level with point B
to within ± 2.5 mm. Repeat the process by
turning the laser to the left.
!
Regularly check the calibration before use, after transport and after
extended periods of storage.
Technical data
Self-levelling range
Accuracy
Operating range (depending
on room illumination)
Laser wavelength
Laser class
Power supply
Operating time
Operating temperature
Storage temperature
Dimensions (W x H x D)
Weight (incl. batteries)
EU directives and disposal
This device complies with all necessary standards for the free
movement of goods within the EU.
This product is an electric device and must be collected
separately for disposal according to the European Directive
on waste electrical and electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
SmartCross-Laser
B
Subject to technical alterations. 01.17
± 5°
± 0.5 mm / m
10 m
650 nm
2 / < 1 mW
2 x 1.5 V alkaline batteries
(type AA, LR6)
15 hours (alkaline batteries)
0 °C ... +40 °C
-10 °C ... +70 °C
55 x 85 x 75 mm
260 g
2,5 m
C
07
EN