7.5.3 Turning on the work surface light
To turn the machine's compartment light on and off,
press the (
) switch.
7.5.4 Raised cup grilles
When using cups with different heights, the special
retractable grilles (10) that are supplied with the machine
can be used.
To use the pull-out grille, extract it from its storage
position by pulling it outwards until it is fully locked in
position.
When the grille is no longer needed, push it back in
towards the machine until it disappears completely into
its storage position.
10
USER manual
Coffee dispensing
7.6
7.6.1 Programming
T h e m a c h i n e i s p r o -
grammed by default. Should
the coffee doses need to be
modified, proceed as follows:
Always programme the
left push button panel
first. This way, all the push
ON/OFF
Dispensing
button panels will be au-
compartment
tomatically programmed.
light
If necessary, subsequently
programme the others;
Press and hold the
ton down for 5 seconds: the
button will flash and
P
rog
S
top
all the push button panel
buttons being programmed
will turn on;
Fill the filter with a dose of
ground coffee and press
it down using the coffee
press;
Attach the filter holder to
the dispensing group;
Place the coffee cup under
the dispensing spout;
Press the desired dose but-
ton (e.g.
All of the LEDs will turn off,
except for the dose buttons
being programmed;
Wait for the dispensing
process to finish; to confirm
the dose, press the dose
button again or the
button.
Repeat this operation for
the other dose buttons;
When you have finished
programming, press the
button to voluntarily
P
rog
S
top
exit the dose programming
mode.
Every dose must be programmed with ground coffee and not
previously used coffee dregs.
P
rog
S
top
P
rog
but-
S
top
);
P
rog
S
top
P
rog
S
top
57
260
of