Operating And Maintenance Instructions; General Operating And Maintenance Instructions; Cleaning; Shutdown And Storage - Solo 113 Manual De Instrucciones

Operating and maintenance instructions

7. Operating and maintenance
instructions
7.1 General operating and maintenance
instructions
The maintenance and the repair of modern
machines as well as their safety-relevant assemblies
require qualified specialised training and a
workshop equipped with special tools and test
equipment. Consequently the manufacturer
recommends that all tasks not described in these
operating instructions be carried out by a specialised
workshop. That specialist has the required training,
experience, and equipment at his disposal, to
provide you with the most cost-effective solution for
such work. He will provide additional help in word
and deed.
After a running-in time of app. 5 hours, check all
accessible screws and nuts for tightness and
retighten them, if required.
Inspect the cutting tool regularly (short intervals)
and when you notice unusual vibrations or the
cutting area or guard has become jammed/blocked.
For this switch OFF the motor, and the cutting tool
must be at a complete standstill. Pull the mains plug
and remove grass cuttings, brush etc. from the tool
base.

7.2 Cleaning

Before cleaning always switch OFF the motor and
pull the mains supply plug from its socket.
Never hose down this power tool.
Clean cuttings from the cutting area with a hand-
held brush.
Only use a dry or slightly damp cloth to clean the
entire machine. Never use solvents or abrasive
cleaning agents. Before connecting the
equipment to the mains supply, the motor casing
and its interior must not be damp.

7.3 Shutdown and storage

Store the equipment in a dry secure location. Open
flames and similar should not be nearby. Prevent
unauthorised access – particularly by children.
ENGLISH 10