1
Inserting the battery
Isolate the device from all measuring circuits before opening
the battery compartment cover. It is recommended that you replace
the batteries in the sender: When the status indicator light is weak.
The batteries in the receiver should be replaced: If the signal volume
becomes lower despite the fact that the position of the device or
the volume control (13) has not changed. Do not switch on the
device with the cover open.
Ensure correct polarity!
2 x 1,5
V type AAA
AUTO OFF function
In order to preserve the batteries, the meter
switches off automatically if it is left idle
for 30 minutes.
Notes on measurement
2a
Transmitter TX
1. Open cover (3)
2. Feed the required test adapter
through opening (5)
3. Close cover (3)
4. Connect test adapter to circuit
5. Switch on transmitter (2),
status indicator (4) flashes
CableChecker
4 x LR44
1,5 V button cells
11
GB