1
Inserting the battery
Isolate the device from all measuring circuits before opening the
battery compartment cover. It is recommended that you replace
the batteries in the sender: When the status indicator light is
weak. The batteries in the receiver should be replaced: If the signal
volume becomes lower despite the fact that the position of the
device or the volume control (13) has not changed. Do not switch
on the device with the cover open.
Ensure correct polarity!
AUTO OFF function
In order to preserve the batteries, the meter switches off automatically
if it is left idle for 30 minutes.
Notes on measurement
2a
Transmitter TX
1. Open cover (3)
2. Feed the required test adapter
through opening (5)
3. Close cover (3)
4. Connect test adapter to circuit
5. Switch on transmitter (2),
status indicator (4) flashes
10
EN
2 x 1,5V LR03 (AAA)
1
2
4 x 1,5V LR44 (AG13)
3