LaserLiner MultiMeter XP Manual De Instrucciones página 21

Connection of test prods
3
The black test prod (–) must always be connected to the „COM socket". Connect the red test prod (+)
as illustrated.
Current measurement 10 A
Please ensure that the test prods are connected correctly before each measurement.
!
Taking a voltage measurement with 10 A current connectors plugged in or in the mA range
can cause the built-in fuse to trip and damage the measuring circuit.
Current measurement AC/DC
4
!
Disconnect the circuit before connecting the meter.
1.
μA / mA / 10A
!
Do not measure currents in the 10 A for longer than 30 seconds. This could damage the device
or the test prods.
Voltage measurement AC/DC
5
1.
V AC/DC
Voltage, resistance, frequency,
duty factor measurement, diode,
continuity check, capacitance
measurement, contact temperature
measurement
2.
AC/DC
selection
2.
AC, DC, Hz
and % selection
MultiMeter XP
Current measurement μA and mA
3.
Red Black
Connect the measuring contacts
to the object to be tested
3. Black
Connect the measuring contacts
to the object to be tested
Red
21
EN