Hold Function - LaserLiner MultiMeter XP Manual De Instrucciones

Backlight
21
Long-press the button (4) to switch the backlighting on and off. The backlighting switches on auto-
matically in dark conditions.

Hold function

22
The „Hold" function enables you to keep the current measured value on the display.
Press the „HOLD" (4) button to activate and deactivate the function.
Replacing the fuse
23
To replace the fuse, first disconnect the test prods from their voltage source and then from the device.
Open the housing and replace the fuse with one of the same type and specification (10A / 1000V or
800mA / 1000V). Close the housing and carefully screw the meter back together.
Information on maintenance and care
Clean all components with a damp cloth and do not use cleaning agents, scouring agents and solvents.
Remove the battery(ies) before storing for longer periods. Store the device in a clean and dry place.
Calibration
The meter needs to be calibrated and tested on a regular basis to ensure it produces accurate
measurement results. We recommend carrying out calibration once a year.
Data transfer
The device features a Bluetooth
a Bluetooth * interface (such as a smartphone or tablet).
®
The system prerequisites for a Bluetooth
The device can set up a Bluetooth
The range is set to a maximum distance of 10 m from the terminal device and greatly depends on the
ambient conditions such as the thickness and composition of walls, sources of interference as well as
the transmit / receive properties of the terminal device.
Bluetooth * must be activated after switching on the device as the measuring system or measuring
®
device is designed for very low power consumption.
A mobile device can link up to the active measuring device via an app.
26
EN
* function that enables wireless data transfer to mobile devices with
®
* connection are specified at http://laserliner.com/info?an=ble
®
* connection with Bluetooth 4.0 compatible devices.
®
800