Publicidad
Idiomas disponibles
Idiomas disponibles
Operating instructions
4.7 - Lowering:
The manoeuvre of lowering is obtained
by the opposite way. Lift the blockade on the
safety catch (M2) and rotate the hand crank of
the winch in a counterclockwise (N
the load until that the second profile would be
completely folded. Lift the blockade on the
safety catch (M1) and continue lowering the
load until that the tower would be completely
folded down to its minimum height.
The tower can be left in any intermediate
position wich would be necessary, the same as
lifting the load.
4.8 - For the transport of the tower is necessary
to fold the tower lowering completely all the
profiles, blockading them with the safety catch
(M1, M2). Close the support system (SA) and
then fix the safety catch pawl (R).
5. MAINTENANCE
5.1 - The cable is to be regulary checked for
wear (ie: kinks, single strund breakage). Faulty
cables must be replaced immediately. Do not
use the elevator tower with faulty cables.
Only use handle cables DIN 3060.
5.2 - The elevator tower has been lubricated in
the workshop. It is nevertheless recommended
that oil is regulary applied to the gear drive, the
bearing bushes on the drive shaft and to the
drum hub, the thread of the handle and the
profiles of the tower.
ATTENTION:
Do not apply oil or grease to the brake
mechanism.
The brake washers have been pregreased
with an special warmth and pressure resistant
grease. Do not use other greases as this will
effect the winch brake performance.
It is not necessary greasing the brake
washers.
VMB ESPAÑOLA, S.A.
5.3 - The elevator tower TE-034 must be
inspected by trained personnel at least once
annually.
) lowering
5.4 - In order to maintain this guarantee of
2
function and safety, original parts of the
manufacturer's design must be used.
The user forfeits all rights to claim if parts
other than those of the manufacturer are used
or modifies the product in any other way.
5.5 - When any spare part would be required,
it is necessary to indicate its reference number,
wich is included in the spare part of this ma-
nual.
6. CERTIFICATIONS
-
EC Machinery Directive
- BGV C1 (GUV-VC1) / BGG 912 (GUV-G912)
v10.06 - Depósito legal y Copyright 2009. Todos los derechos reservados.
ENGLISH
89/392/ECC and 98/37/ECC
-
Publicidad
