Installation
WARNING! RISK OF FIRE!
►
Never place the appliance beneath wall
cabinets or adjacent to curtains, wall units
or other flammable objects.
►
A minimum clearance of 10 cm must be
maintained between the appliance and wall
cupboards, ceilings, walls or similar structures,
measured upwards of the appliance, and
5 cm measured laterally. For this reason the
appliance may not be used, for example, in
cupboards or similar. Otherwise there is likely
to be insufficient ventilation for the appliance,
which could result in fire or damage.
►
Always place the appliance on a heat-
resistant surface. Failure to do so increases
the risk of fire or of the appliance being
damaged. The surface under appliance
may become discoloured and be damaged.
Additionally,
permanent indentations could arise if the
appliance is placed on a soft surface.
DANGER! ELECTRIC SHOCK!
►
Do not place the appliance immediately
adjacent to sources of water, e.g. sinks or
basins, or in damp cellar areas. Otherwise,
there is a risk of receiving an electric shock.
■
Place the appliance on a solid, level and heat-
resistant surface (e.g. stainless steel worktops
or natural stone worktops such as granite).
Ensure there is sufficient ventilation around the
appliance.
■
Push the appliance up against the wall, with its
rear side facing the wall. The spacers on the
back must touch the wall. Ensure that the wall is
made of heat-resistant material, e.g. tiles, natural
stone or granite.
■
Clean all components as described in the section
"Cleaning and care".
■
54
│
GB │ MT
Using the appliance
Glass door
CAUTION! PROPERTY DAMAGE!
►
Do not lean on the glass door. Do not place
objects on the glass door. This can cause
damage to the door hinges.
■
Cooking some foods, especially fatty foods,
can result in increased smoke production. In this
case, do not close the glass door completely;
instead, leave it slightly open.
The glass door has a latching position so that
it remains open a little: if you carefully push
the glass door closed, it clicks into this position
shortly before closing completely.
Inserting the crumb tray
Push the crumb tray 7 under the lower heating
■
element so that it rests flat on the bottom of the
appliance.
Using the rack
WARNING! RISK OF INJURY!
Always use the tongs 0 to insert the rack 8
►
into the appliance or to remove it.
Push the rack 8 onto one of the 2 rails 1 in the
■
cooking chamber of the appliance.
CAUTION! MATERIAL DAMAGE!
Never place the rack 8 directly upon the
►
heating elements.
SGB 1200 B5