JF MIX 4000 CS Manual De Instrucciones página 36

REPLACEMENT OF REAR LOAD SENSORS
AT TENTION: T
TracTor and remove The igniTion
key before you sTarT The following
procedure
In a leveled surface, with the Wagon leveled and
after adding shims to the wheels:
1.
Open the cover from the junction box (A),
and disconnect the plug (B) corresponding
to the sensor, which is going to be replaced.
2.
Using an appropriate side-cutting plier, cut
the plastic clips that fasten the cables.
3.
Remove the two rubber guides (C).
4.
Tie the wire to the connector and pull the
cable. The use of wire will make the cable
passage easier when you assemble the new
load sensor.
5.
Loosen the two bolts (K), pushing them
against the plate (L), until you relieve the
weight over the load sensor. In order for
the load sensor to be removed, it must be
completely loose and with no load.
IMPORTANT!
T
he procedure described in iTem
be performed on boTh bolTs
.
The nexT sTep
6.
Remove the nut (M), using a 50mm
screwdriver.
36
u r n o f f T h e
.
5
above musT
(k)
before you Take
Instructions Manual
A
B
1
C
K
M
CÉLULAS
K
L