Extel WECR 55502 Instrucciones De Uso E Instalación página 13

English
In order to ensure proper installation and use of your chime, please read
and apply the following instructions.
Transmission frequency: 433MHz
1 - Content of the kit:
- 1 wireless battery operated chime (3 x type AA or LR06 batteries, not-supplied).
- 1 wireless 12V battery operated call button (1x type A23 or MN21 battery).
- 1 wireless battery operated movement detector
(3 x type AAA or LR03 batteries, not-supplied).
- 1 user manual.
2 - Installation and activation of the chime:
a - Insert the 3 batteries into the chime respecting the polarity specified inside
(figure 1)
the housing.
b - Fix a screw at the desired place (preferably at height) and hang the chime at a reaso-
nable height using the keyhole . For mobility purposes, you can remove the chime
(figure 2)
from its place at any time.
(Caution, sometimes it is necessary to move the chime for improved reception).
Do not fix this chime on metal surface, because it will affect the performance.
c - When the melody rings, an LED illuminates on the front of the chime.
3 - Installation and activation of the call button:
The call button can be used in a fixed or mobile way
a - Remove gently the transparent cover , write down your name on the white
(figure 3)
paper label and insert it.
b - To open the button, slide a screwdriver in the top slot, apply a slight pressure and take
off the base of the button
(figures 3 & 4)
Important: do not not lose or stretch the sealing ring
(J)
c - Remove the plastic insulator from one of the battery terminals, noting the correct
polarity of the battery
(figure 5).
Choose the appropriate place to fix your button, a place protected from rain is advisable,
check the chime is working properly before fixing it.
Do not fix this call button on metal surface, because it will affect its performance.
The range of your button depends on the configuration of the installation, in open space
it can reach 70 metres.
Then screw the wall bracket in your chosen location . In case of "vertical" instal-
(figure 4)
lation , place the "name holder" part on the top and the button to the bottom.
d - Check the sealing ring is correctly located and locate the button on its wall bracket.
(J)
4 - Installation ad activation of the passive motion detector (PIR) (Do not place this
detector outdoors)
a - Insert the 3 batteries into the PIR detector respecting the polarity specified
(figure 6)
at the housing bottom.
b - Determine the best place to locate the PIR detector. The detection area covers an angle
of 110 ° over approximately 6 metres. The detector can be directed upward and
downward on its fix support. The range of your PIR detector depends on the installation
, in open air its range can reach 30 metres.
c - The switch located at the back of the detector allows to switch the device, «ON»
position and to switch off the detector, «OFF» position. Before fixing the PIR detector,
check for its coverage and its operation, with the chime.
d - Once installed, the chime emits a ring tone, non-modifiable, type "ding-dong", with a
light signal. To differentiate the ring tone of the PIR detector and of the call button, do
not select this ring tone for the call button.
e- - Remove the PIR detector from its bracket , then you can access access the
(figure 7)
fixing holes . To finish, , locate the detector securely into place onto its two
(figure 8)
supports.