Battery Installation; Refill Replacement - Walter SURFOX Manual Del Usuario

SURFOX Stainless steel passivation tester

3. Battery installation

1. Unscrew the cover of the battery box compartment.
2. Insert/replace the batteries (4x AA 1,5 V).
3. Close the cover of the battery compartment.
NOTE: Batteries are included with the tester.

4. Refill replacement

WARNING: Wear gloves during the operation to avoid
direct contact between the electrolyte solution and
the skin.
1. Unscrew the cap (7) of the cartridge compartment.
2. Remove and replace the cartridge by a new one.
3. Screw the cap (7) back on the compartment. (Fig. 2)
Attention: Ensure the cap is screwed on properly to avoid the evaporation of
the electrolytic solution.
6
Fig. 2