Bostitch DSA-3519-U Instrucciones De Funcionamiento página 9

d) Store idle power tools out of the reach of children
and do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool's
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.,
in accordance with these instructions taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) BATTERY TOOL USE AND CARE
a) Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type
of battery pack may create a risk of fire when used
with another battery pack.
b) Use power tools only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
c) When battery pack is not in use, keep it away from
other metal objects like paper clips, coins, keys, nails,
screws or other small metal objects that can make a
connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from
the battery may cause irritation or burns.
6) SERVICE
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
SAFETY INSTRUCTIONS
FOR STAPLERS
• Always assume that the tool contains fasteners.
Careless handling of the stapler can result in
unexpected firing of fasteners and personal injury.
• Do not point the tool towards yourself or anyone
nearby. Unexpected triggering will discharge the
fastener causing an injury.
• Do not actuate the tool unless the tool is placed firmly
against the workpiece. If the tool is not in contact with
the workpiece, the fastener may be deflected away
from your target.
• Disconnect the tool from the power source when the
fastener jams in the tool. While removing a jammed
fastener, the nailer may be accidentally activated if it
is plugged in.
• Do not use this stapler for fastening electrical cables.
It is not designed for electric cable installation and
may damage the insulation of electric cables thereby
causing electric shock or fire hazards.
ADDITIONAL SAFETY EQUIPMENT
EYE PROTECTION which provides
protection against flying particles both
from the FRONT and SIDE should
always be worn by the tool operator
and others in the work area when loading, operating or
servicing this tool. Eye protection is required to guard
against flying fasteners and debris, which could cause
severe eye injury. The employer and/or user must
ensure that proper eye protection is worn.
Eye protection in accordance with 89/686/EEC, and with
equal or greater grade than defined in EN166 should
be used. However all aspects of the operators work,
environment and other type/s of machinery being used
should also be considered when selecting any personal
protection equipment.
Note: Non-side shielded spectacles and face shields
alone do not provide adequate protection.
m CAUTION: ADDITIONAL SAFETY
PROTECTION may be required in some
environments. For example, the working
area may include exposure to noise
levels that can lead to hearing damage. The employer
and user should ensure that any necessary hearing
protection is provided and used by the operator and
others in the work area.
GB