Troubleshooting - Stihl BGA 85 Manual De Instrucciones

English

Troubleshooting

Always remove the battery before carrying out any work on the power tool.
Condition
Machine does not start when switched on
Machine cuts out during operation
Runtime is too short
Battery jams when being inserted in machine
/ charger
Battery is not being charged even though
LED on charger glows green
22
Cause
No electrical contact between machine
and battery
Battery is low on charge
(1 LED on battery flashes green)
Battery too hot / too cold
(1 LED on battery glows red)
Fault in battery
(4 LEDs on battery flash red)
Machine too hot
(3 LEDs on battery glow red)
Fault in machine
(3 LEDs on battery flash red)
Moisture in machine and/or battery
Battery or machine's electronics too hot Take battery out of machine, allow bat-
Electrical fault
Battery not fully charged
Useful life of battery has been reached
or exceeded
Guides / contacts dirty
Battery too hot / too cold
(1 LED on battery glows red)
Remedy
Remove the battery, visually check con-
tacts and refit battery
Charge the battery
Allow battery to cool down / at tempera-
tures of about 60°F - 70°F (15°C - 20°C),
allow battery to warm up slowly
Take the battery out of the machine tool
and refit it. Switch on the machine – if the
LEDs continue to flash, the battery has a
malfunction and must be replaced.
Allow machine to cool down
Take the battery out of the machine tool
and refit it. Switch on the machine – if the
LEDs still flash, the machine has a mal-
function and must be checked by a
1)
servicing dealer
Allow machine / battery to dry
tery and machine to cool down
Remove the battery and refit it
Charge the battery
1)
Check battery and replace
Carefully clean the guides / contacts
Allow battery to cool down / at tempera-
tures of about 60°F - 70°F (15°C - 20°C),
allow battery to warm up slowly
Operate charger only in closed, dry
rooms at ambient temperatures of 40°F -
105°F (5°C - 40°C)
BGA 85