Safety - BADECO M4-ASF Instrucciones De Uso

Safety

a. Never dismantle ! Material to be sent only to BADECO Geneva for repair.
b. Do not plug out by pulling the cable. The box should be disconnected to move
it.
c. Whole system should not get in contact with dusts, metallic chips and liquids.
d. System should not be used if electric cable is in bad condition or if the box has
fallen on the floor and damages have been caused.
e. It is recommended to wear spectables.
f. Too ample clothes could get caught with the drill.
g. Low speed will considerably increase the life expectancy of all tools.
h. Motor, handpiece and mallet should not run when not in use.
i. Stop the motor to change the handpiece, mallet as well as drills, milling,
cutters, wheels, points, etc.
j. Motor and electronic box should not be oiled.
k. Diameter of the spindle has to be exactly the same as that of the burr holder
of the handpiece and has to be perfectly clean and even on all its length. A
spindle in poor condition will damage the handpiece.
l. After each utilization, micromotor has to be put back on its bracket.
- 23 -
www.badeco.com
SWISS MADE