SpeedEPart Agri-Fab 45-01841 Manual Del Usuario página 5

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
9. Assemble the front panel over the end of the cart
using six 1/4" x 1/2" hex bolts and 1/4" hex nuts as
shown in figure 5. Leave two holes in the bottom of
the panel empty as shown. With the cart body
halves pulled together, tighten the bolts in the
bottom of the front panel, then tighten the bolts in
the sides. See figure 5.
At this time tighten the bolts assembled in step 4,
which fasten the bottom of the cart together.
LEAVE HOLES OPEN FOR
LATCH STAND BRACKET
1/4" HEX NUT
FIGURE 5
10. Assemble the wheel support to the cart using eight
5/16" x 3/4" truss head bolts and 5/16" hex nuts as
shown in figure 6. Heads of bolts go on the inside
of the cart. Tighten.
WHEEL
SUPPORT
5/16" HEX
NUT
FIGURE 6
ENGLISH
1/4" x 1/2"
HEX BOLTS
1/4" HEX NUT
5/16" x 3/4"
TRUSS HEAD BOLT
www.mymowerparts.com
11. Turn the latch stand bracket so that the aligning tab
is at the rear (bottom) of the bracket. Assemble the
latch stand bracket to the cart using four 1/4" x 1/2"
hex bolts and 1/4" hex nuts. TIGHTEN. See figure 7.
LATCH STAND BRACKET
ALIGNING TAB
AT BOTTOM
1/4" HEX NUT
FIGURE 7
12. Assemble the two corner caps to the front corners of
the cart using four 1/4" x 1/2" hex bolts and 1/4" hex
nuts. Also assemble two 1/4" x 1/2" hex bolts and
1/4" hex nuts to the two rear corners of the cart.
TIGHTEN. See figure 8.
CORNER CAP
1/4" x 1/2"
HEX BOLT
FIGURE 8
5
1/4" x 1/2"
HEX BOLT
1/4" HEX NUT
1/4" HEX
NUT