P Hitch Pin - SpeedEPart Agri-Fab 45-01841 Manual Del Usuario

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
19. Assemble the end of the hitch bracket (two holes)
down through the slot at the front of the drawbar
tongue. Fasten it to the tongue using the 3/8" x 1"
hex bolt, 3/8" lock washer and 3/8" hex nut.
Tighten. See figure 13.
20. Assemble the hitch pin through the hitch bracket
and the tongue and secure with the 1/8" hair cotter
pin. See figure 13.
HITCH PIN
HITCH
BRACKET
1/8" HAIR
COTTER
PIN
FIGURE 13
21. Place the tailgate down into the tailgate guides so
that the holes in the bottom lip of tailgate fit over
the slotted head screws in the bottom of the cart.
This completes the assembly of your cart.
OPERATION
CAUTION: VEHICLE BRAKING AND
STABILITY MAY BE AFFECTED WITH
THE ADDITION OF AN ACCESSORY
OR AN ATTACHMENT. BE AWARE OF
CHANGING CONDITIONS ON SLOPES.
1. Refer to the vehicle owners manual for instructions
on safe operation on slopes.
2. Use the slope guide provided on page 9 of this
manual to determine if slope angle is not too steep for
safe operation.
3. For best handling and traction, distribute the weight
of the load evenly in the cart.
4. Always test to make sure your tractor has adequate
towing and braking capabilities whenever hauling a
substantial amount of weight in your cart. Use extra
caution when operating on slopes.
ENGLISH
3/8" x 1"
HEX BOLT
TONGUE
3/8" LOCK
WASHER
3/8" HEX
NUT
7
www.mymowerparts.com
DO NOT EXCEED WEIGHT CAPACITY OF CART
(See the specifications on this page for each model)
One cubic foot of dirt weighs approximately 150 lbs.
5. To dump material from the cart, remove the tailgate
by lifting it straight up and out from between the
guides. Release the spring latch on the tongue by
pulling the latch lock lever forward, away from the
cart. The cart bed will then tilt backwards to empty its
contents. After emptying, pull the front of the bed
down toward the cart tongue until the latch snaps into
place. Replace the tailgate if desired.
6. The maximum towing speed for this cart is 10 m.p.h.
CAUTION:
INJURY, BEFORE RELEASING THE
LATCH BE SURE THAT NO ONE IS
NEAR THE CART.
MAINTENANCE
1. At the beginning of each season, lubricate, with a
light machine oil, the latch, the latch pivot bolt,
and the area of the axle where the draw bar tongue
pivots .
2. Grease or oil the wheel bearings periodically. Use
automotive wheel bearing type grease or 20 weight
oil.
3. Keep tires filled to the recommended tire pressure
of 12-14 Lbs.
CART MODEL SPECIFICATIONS
MODEL 45-02401 - 15 Cu. Ft. (H.D.)
Tires: 16.00" x 6.5" Pneumatic, Turf Tread
Axle: 1.0" Dia. Steel
Capacity: Up to 1200 Lbs. Max.
Approx. Sh. Wt. 157 Lbs.
MODELS 45-01841, 190-425A - 17 Cu. Ft. (H.D.)
Tires: 16.00" x 6.5" Pneumatic, Turf Tread
Axle: 1.0" Dia. Steel
Capacity: Up to 1500 Lbs. Max.
Approx. Sh. Wt. 180 Lbs.
NOTE
TO AVOID POSSIBLE